How to Fit a Filter Tip in a Joint: Step-by-Step Guide

Quick Answer

To fit a filter tip in a joint, roll a small piece of cardboard into a cylinder, place it at one end of the rolling paper, add ground cannabis, and roll the paper around both the tip and the flower. Tuck the near edge, seal the paper, and pack the joint from the open end.

how to fit a filter tip in a joint

What You Need

• Rolling papers
• Ground cannabis
• Cardboard filter tip or pre-made crutch
• Grinder (optional)
• Packing tool or pen (optional)

Step-by-Step Guide

1. Choose a filter tip. Use a pre-made cardboard crutch, a glass tip, or a strip of thin cardboard.
2. Cut or tear the cardboard into a strip about 1 inch wide and 2 to 3 inches long.
3. Fold the strip back and forth in a tight accordion pattern.
4. Roll the folded strip into a cylinder to form the crutch.
5. Place the crutch at one end of the rolling paper, flush with the edge.
6. Sprinkle ground cannabis along the paper, leaving the crutch area empty.
7. Roll the paper over the cannabis and the crutch, tucking the near edge under the flower.
8. Lick the gum strip and seal the paper.
9. Pack the open end with a tool or pen to compress the flower.
10. Twist the open end closed or leave it open for a draw.

Tips for a Tight Fit

• Use a crutch that matches the width of your rolling paper.
• Keep the crutch a bit wider than the joint so it stays in place.
• Do not use cigarette filters because they trap cannabinoids.
• Wet the crutch a little if it keeps sliding out.

Common Mistakes

• Rolling the crutch too loose causes it to fall out.
• Placing the crutch too far inside the paper makes it hard to draw.
• Using too much flower near the crutch can block airflow.