What is Full Melt Hash?
Full Melt Hash is a potent cannabis concentrate known for its smooth and consistent melt.
The short answer
Full melt hash dabs best between 450°F and 550°F. On an e-nail I keep mine at 480-510°F. With a torch and a quartz banger, you want the banger near 500°F at the moment the hash touches it. Cold starts can run a bit lower, around 440-470°F, because the heat climbs while you're drawing.
Push past 600°F and you get a hot, acrid hit that tastes like burnt plant matter. That's a waste of good resin.
Top Pick for Cannabis Full Melt Hash Reviews: [Brand X]
Why full melt wants a lower number than BHO
Full melt is mostly intact trichome heads. Ice water extraction and dry sift keep the resin glands whole, so there's no solvent stripping away waxes and no winterization step changing the structure. What you get is a fragile, terpene-rich material with a low melting point.
Live resin and shatter will happily take 550-600°F. Full melt will not. The monoterpenes that carry the smell and the flavor start boiling off well before that, and once they're gone the dab goes flat. Gentle heat gives you more of the profile and less of the cough.
cannabis full melt hash for sale
Temps by setup
E-nail or e-rig
Set it to 480-520°F. Consistency is the whole point of an e-nail, so pick a number, hold it, and adjust by 10 degrees at a time until the vapor feels right for your material.
Quartz banger and torch
Heat until it glows, then wait. For most 4mm-wall bangers that's 40-60 seconds of cooling. An infrared thermometer takes the guesswork out. Without one, count and adjust on the next dab.
Cold start
Load the hash first, cap it, then heat the bottom until the resin bubbles and starts to melt. Peak temp lands around 440-470°F. Excellent flavor, but it's harder to finish a large load.
Reading the dab
- Too cold: a puddle that never really vaporizes, weak flavor, and a harsh reclaim taste.
- Just right: thin white vapor, immediate melt, strain flavor up front, and a faint residue left in the banger.
- Too hot: vapor arrives fast and dark, throat burn, and a black ring that chazzes the quartz.
Technique matters as much as the number
- Use a small load. 0.05 to 0.1 grams is plenty for full melt.
- Cap it. Restriction builds vapor density and keeps heat in the banger.
- Draw slow and steady rather than hard. Fast pulls just cool the nail.
- Q-tip the banger while it's still warm so residue doesn't bake on.
- Let the banger cool between dabs. Back-to-back hits drift hotter than you think.
Does residue mean it isn't full melt?
True full melt leaves very little behind. A faint ring or a speck of plant matter is normal for anything below 6-star. If you're scraping out a black pool, either the hash isn't full melt or you're running way too hot. The star ratings people throw around come down to how cleanly a sample melts and how much it leaves on the nail.
Storage and handling
Keep full melt in glass, cool and dark. For long storage, the fridge works, but let the jar come to room temperature before opening so condensation doesn't land on the resin. Use a cold tool or parchment when you're portioning it out, and keep your fingers off the hash. Skin oil ruins the melt faster than heat does.